Owner`s manual
43
Tutorial 3:
Natural Vibrato Function
This tutorial will demonstrate the use of the Natural Vibrato function using
the same audio file we used in the previous tutorial.
Begin the tutorial by doing the following:
1. Load or import “wide_vibrato” into a track of your host program. This is
a recording of a male voice singing a sustained “G” with a pronounced
vibrato. Play the track so that you are familiar with the original audio.
2. Set up Auto-Tune Live to be an insert eect on that track.
3. Set the Key to “C” and the Scale to “Chromatic.”
4. Set the Input Type to Low Male Voice
5. Set Retune Speed to a value of 24.
6. Set “wide_vibrato” to loop continuously and put your host program into
Play mode.
7. Set Natural Vibrato to 12 and note the eect on the vibrato. Set Natural
Vibrato to -12 and note the eect on the vibrato.
8. Set all Scale notes to Bypass to disable any pitch correction. Again, adjust
Natural Vibrato as in Step 7 and note that its eect is still active.