Owner`s manual
38
ONSET EXAMPLE: As an example of the above parameters, assume an Onset
Delay of 1000ms and an Onset Rate of 750ms. In that case, each time a
new note starts there will be no vibrato at all for the first second (1000ms)
followed by a 3/4 second (750ms) period during which the vibrato depths
will increase from none to the full amounts set in the various Amount
parameters — for a total of 1.75 seconds from the beginning of the note to
the time full vibrato depth is reached.
Pitch Amount
Sets the amount that the pitch changes. The range is from 0 (no change) to
100 (maximum change). The default setting is 18. Command (Mac)/Control
(PC) clicking the slider will reset it to that value.
Amplitude Amount
Sets the amount that the loudness changes. For the most realistic vibrato,
the amount of amplitude change should be substantially less than pitch
change, although for special eects, anything goes.
The range is from 0 (no change) to 30 (maximum change). The default
setting is 10. Command (Mac)/Control (PC) clicking the slider will reset it to
that value.
Formant Amount
Sets the amount that the resonant timbre changes. The range is from 0 (no
change) to 100 (maximum change). The default setting is 70. Command
(Mac)/Control (PC) clicking the slider will reset it to that value.
NOTE: The vibrato is re-started every time Auto-Tune Live matches the
incoming pitch to a dierent scale tone. Also, the vibrato is applied after
the eects of the Retune Speed control. Hence, even with a slow retune
value of 50, a square wave vibrato will make instantaneous changes in
pitch.