User Manual

5
Chapter 3: Using Mic Mod EFX
Live or Mixdown?
Mic Mod EFX functions equally well processing
audio during its original performance or later
during the mixdown process. However, if you
have the choice (which you typically will for
everything but a live stage performance), we
strongly recommend using Mic Mod EFX as
an insert effect during mixdown. This will allow
you to experiment with mic choice and various
mic settings while auditioning their effect in the
context of the entire mix.
If you do choose to work this way, it is
important that you carefully document all
mic data for each recorded track. This should
include the mic used, any settings such as low-
cut filter and/or response pattern selected, as
well as the average distance between the mic
and the signal source (singer, instrument, etc.).
This information will be required to properly set
the Source Mic controls during the mix.
Signal Flow
Mic Mod EFX is divided into a number of
discreet functional blocks as follows (in the
order of signal flow):
Input For setting the input level of the audio
to be processed.
Source Mic For indicating the mic (and
the state of its various parameters) that was
actually used to record the audio.
Modeled Mic For selecting the mic (and the
state of its various parameters) whose sound
you would like to model.
Tube Saturation For adding a model of
analog tube saturation distortion.
Output For setting the output level of the
processed audio. The use of each of the
individual controls is covered below.
Mic Mod EFX Controls
Input Section
The Input Gain
slider, as is no doubt
obvious, is used to
set the level of the
incoming audio. The
exact amount of
gain or attenuation is
displayed numerically
above the slider. In
most instances, the
input gain should be
set at the highest level
that does not cause
the 0 dB area of the
graphic level meter to
light.
The Level Meter
displays the level of
the audio as it is being
processed by both the
Source and Modeled
Mic models. Because
some models (or combinations of models)
can result in increased amplitude at various
frequencies, changing to a different mic model
or changing a model’s settings may require an
adjustment of the Input Gain to avoid clipping
In practice, you should start out by setting the
Input Gain at a bit under the optimum level.
Once you’re confident that you’ve found the
right mic settings for your track, you should go
back and fine tune the gain for maximum level
without clipping.