User Manual

32
If you click the Assign button and then realize
that you forgot to type a name for your preset,
you can still click the name field and type a
name before clicking a preset button to assign
the preset.
If you click the Assign button and then, for
some reason, change your mind, simply click it
again to exit Assign mode.
To edit an existing preset:
1. Click the existing preset’s button to call up
its parameters and place its name in the
Name field.
2. Edit the parameters as desired.
3. Click the Assign button and then the
preset’s button. The updated values will be
recorded and the preset’s name will remain
the same. Optionally, you can modify the
preset name (which will already be in the
Name field) before assigning the edited
preset to the button.
To create a new preset based
on an existing preset:
1. Click the existing preset’s button to call up
its parameters and place its name in the
Name field.
2. Edit the parameters as desired.
3. Click in the Name field and type a name for
the new preset.
4. Click the Assign button and then the preset
button to which you want to assign the
new preset.
A TIP: Don’t forget to change the
name of the new preset before
assigning it to a button. Otherwise
you end up with two identically named presets
with different control values. Not good.
To delete an existing preset:
1. Click Presets Delete button
2. Click the button whose preset you want
to delete. The selected preset will be
erased and its button will return to the gray
unassigned state.
IMPORTANT NOTE: Voice Parameter
Presets are local to the instance
of Harmony Engine Evo in which
they are created. If you want to share a set of
Harmony Presets among various instances of
Harmony Engine Evo, save the plug-in state
as a preset in your host so that it can then be
recalled as a starting point in any instance of
Harmony Engine Evo.