User Manual

31
Voice Parameter Presets
The Voice Parameter Preset system allows
you to assign combinations of voice parameter
settings to each of 6 buttons for instant recall,
either manually or via automation. This makes
it easy to instantly change the timbre and
configuration of your “vocal group” at any point
in your song.
Voice Parameter Presets store the values of the
following controls:
Naturalize
Pitch Variation
Timing Variation
Glide Transition Rate
Original Input:
Solo Mute
Tracking Gain
Pan
Harmony Voices 1-4:
Solo Mute
Gain Throat Length
Pan Vibrato Rate
Onset Delay Pitch Amount
Amplitude Amount
CHOIR
Choir Bypass
Choir Size Vibrato
Pitch Timing
Stereo Spread
Input Voice On/Off
Harmony Voice 1-4 On/Off
In normal operation, a button with a preset
assigned to it is blue and displays the first
5 or six characters of the preset’s name. A
button with no preset assigned to it is gray and
displays no text.
When you click a button with a preset
assigned, the preset’s full name will appear
in the Name field and the harmony voice
parameters will be set to their preset values.
Assigning and deleting Voice Parameter
Presets works exactly like the Harmony Presets
described above, with the obvious exception
that you will be working with the six Voice
Parameter Preset buttons and their associated
Name field.
If you’ve already read those instructions, there’s
really no point in reading the rest of this section,
since we just copied and pasted the same stuff
and changed all the references to Harmony
Presets to Voice Parameter Presets. (On the
other hand, if you’re reading the manual out of
order and got here first, you might as well read
about it here.)
To assign a new preset to a button:
1. Set the controls listed above as desired.
2. Click in the Name field below the Voice
Parameter buttons and type a name for
the preset. Remember, the first 5 or 6
characters will be displayed on the button,
so try to pick something that will remind
you what each preset is about.
3. Click the Presets Assign button. The button
will flash red and all of the Voice Parameter
buttons will turn blue.
4. Click on the Voice Parameter button to
which you want to assign the preset. The
Assign button will stop flashing and all
unassigned Preset buttons will once again
turn gray. The selected button will remain
blue and the preset name text will be
displayed.
If you assigned the new preset to a button that
already had a preset assigned to it, the new
preset will overwrite the old one.