User Manual

33
internal Noise Generator functions as the
Audio Signal. (This is useful primarily for
whispering and modulated noise eects.)
INSTANTIATION ON A STEREO
TRACK:
In this configuration,
ARTICULATOR Evo treats the
right channel of the stereo
track as the Control Signal
and the left channel of the
track as the Audio Signal.
As is probably obvious, this
will usually require that you
create the stereo track by
combining (via whatever
method your DAW provides)
the two independent tracks
you wish to use as Control
Signal and Audio Signal
(being careful to ensure that
they are hard panned to the
appropriate channels).
In this configuration, the Audio Signal is
limited to being mono (although it can be
combined with the Noise Generator in Stereo
Noise mode).
INSTANTIATION ON A 
CHANNEL FX BUS:
In this
configuration, ARTICULATOR
Evo treats the surround
channel of the FX bus as the
Control Signal and the left
and right stereo channels
as the Audio Signal.
Again, this will require
that you create the FX bus
channels by combining the
independent tracks you wish
to use as Control Signal and
Audio Signal (again being
careful to ensure that they
are hard panned to the
appropriate channels).
This is the most flexible of the three options,
in that it allows you to process a stereo Audio
Signal.
AUDIO UNITS Some
Audio Units hosts support
sidechain input and some
don’t. Consequently, the
Input Routing section for
the AU version provides
controls that allow you to
set up ARTICULATOR Evo to
take advantage of whichever
capabilities your host
provides.
The Input Routing section
will change to reflect each of
the two possible options:
INSTANTIATION ON A MONO
TRACK:
In this configuration,
you can select either the
sidechain input or the audio track itself as the
Control Signal. If our host supports sidechain
input, you will typically always select it as
the Control Signal. If your host does not
oer sidechain input, select Audio Track.
Depending on your choice, the resulting Audio
Signal source will appear in the Audio Signal
display as follows:
•
If you select SIDECHAIN, the Audio Source
will be the audio track that ARTICULATOR
Evo is instantiated on.
•
If you select AUDIO TRACK, ARTICULATOR
Evo’s internal Noise Generator functions as
the Audio Signal. (This is useful primarily for
whispering and modulated noise eects.)
INSTANTIATION ON A STEREO
TRACK:
In this configuration,
you can select either the
sidechain input or the left
channel of the audio track or
the right channel of the audio
track as the Control Signal. If
our host supports sidechain
input, you will typically
always select it as the Control
Signal. If your host does
not oer sidechain input,
select either the left or right
channel of the audio track.