Manualshelf

User Manual

ManualsBrandsAntaira Technologies ManualsComputers & AccessoriesAntaira LNX-800AG-T Industrial-Grade 8-Port Unmanaged Gigabit Ethernet Switch, DIN-Rail Mount, -40 to 75°C Operating Temperature, Redundant 12 to 48 VDC Power Input
12345678910
7
The following figure shows the 10/100/1000 Ethernet RJ-45 pin outs.
Cabling
Use unshielded twisted-pair (UTP) or shielded twisted-pair (STP) cable for RJ-45
connections: 100Ω Category 3, 4 or 5 cable for 10Mbps connections, 100Ω Category 5
cable for 100Mbps, or 100Ω Category 5e/above cable for 1000Mbps connections.
The cable between the switch and the link partner (switch, hub, workstation, etc.)
must be less than 100 meters (328 ft.) long.
Wiring the Power Inputs
Please follow below steps to insert the power wire.
1. Insert the positive and negative wires into the PWR1 (V1+, V1-) and PWR2 (V2+,V2-)
contacts on the terminal block connector.