Application Guide

[83]
Software User's
Manual
–
Version 3.0
Target IP Address
Setting Description
Factory
Default
IP address
When Host or Network is selected for the target IP filter, you can
enter a specific target IP address in dotted decimal notation.
Notice the invalid IP address configuration is acceptable too, i.e.
0.0.0.0. Normally, an ACE with an invalid IP address will explicitly
add deny action.
0.0.0.0
Target IP Mask
Setting Description Factory Default
IP address
When Network is selected for the target IP filter, you
can enter a specific target IP mask in dotted decimal
notation.
255.255.255.0
ARP Sender MAC Match
Specify whether frames can hit the action according to their sender hardware address field (SHA)
settings.
Setting Description
Factory
Default
0 ARP frames where SHA is not equal to the SMAC address.
Any
1 ARP frames where SHA is equal to the SMAC address.
Any Any value is allowed.
RARP Target MAC Match
Specify whether frames can hit the action according to their target hardware address field (THA)
settings.
Setting Description
Factory
Default
0 RARP frames where THA is not equal to the target MAC address.
Any
1 RARP frames where THA is equal to the target MAC address.
Any Any value is allowed.
IP/Ethernet Length
Specify whether frames can hit the action according to their ARP/RARP hardware address length
(HLN) and protocol address length (PLN) settings.
Setting Description
Factory
Default
0
ARP/RARP frames where the HLN is not equal to Ethernet (0x06)
or the (PLN) is not equal to IPv4 (0x04).
Any
1
ARP/RARP frames where the HLN is equal to Ethernet (0x06)
and the (PLN) is equal to IPv4 (0x04).
Any Any value is allowed.