Application Guide

[205]
Software User's
Manual
–
Version 3.0
Configuration > QoS > QoS Control List
QoS Control List Configuration
This page shows the QoS Control List(QCL) which is made up of the QCEs. Each row describes a
QCE that is defined. The maximum number of QCEs is 256 on each switch.
Click on the lowest plus sign to add a new QCE to the list.
You can modify each QCE (QoS Control Entry) in the table using the following buttons:
: Inserts a new QCE before the current row.
: Edits the QCE.
: Moves the QCE up the list.
: Moves the QCE down the list.
: Deletes the QCE.
: The lowest plus sign adds a new entry at the bottom of the QCE listings.
Setting Description
QCE Indicates the QCE ID.
Port Indicates the list of ports configured with the QCE or 'Any'.
DMAC
Indicates the destination MAC address. Possible values are:
 Any: Match any DMAC.
 Unicast: Match unicast DMAC.
 Multicast: Match multicast DMAC.
 Broadcast: Match broadcast DMAC.
The default value is 'Any'.
SMAC
Match specific source MAC address or 'Any'.
If a port is configured to match on destination addresses, this field indicates the
DMAC.
Tag Type
Indicates tag type. Possible values are:
 Any: Match tagged and untagged frames.
 Untagged: Match untagged frames.
 Tagged: Match tagged frames.
The default value is 'Any'.
VID
Indicates (VLAN ID), either a specific VID or a range of VIDs. VID can be in the
range 1
-
4095 or 'Any'
.