User Manual

Antaira Industrial Ethernet Switches
LMX-0600 Series User Manual V1.2
1
1. Introduction
Antaira Technologies’ industrial managed switches come with a pre-installed “user friendly” web
console interface, which allows users to easily configure and manage the units, whether one is using
a serial console and command line interface(CLI) commands like Telnet, SSH, HTTP (Web GUI) or
simple network management protocols (SNMP).
1.1 Product Overview
Antaira’s LMX-0600 series is a 6-port industrial managed Ethernet Switch that is embedded
with 6*10/100Tx fast Ethernet ports. This series is a fully manageable industrial Ethernet switch
with a pre-loaded Layer 2 network management web console that supports a low voltage
redundant power input range from 12~48VDC with a voltage booster. This product series is IP30
rated, DIN-rail mountable, and has two wide operating temperature models for either a standard
temperature range ( STD: -10°C to 70°C) or an extended temperature range (EOT: -40°C to
75°C). It also provides high EFT and ESD protection for any industrial networking application
within factory automation, ITS, power/utility, water wastewater, and any other outdoor or harsh
environment.
1.2 Product Software Features
 Network Redundancy
 STP, RSTP, MSTP, ITU-T G.8032 Ethernet Ring Protection Switch (ERPS) for
network redundancy

Network Management
 Web UI based management, SNMP v1/v2, Serial Console
 Qos, traffic classification QoS, Cos, bandwidth control for Ingress and Egress,
broadcast storm control, Diffserv
 IEEE802.1q VLAN, port-based VLAN support
 IGMP snooping v1/v2, IGMP filtering / throttling, IGMP query up to 256 group
 Supports RMON, MIB II, port mirroring, event syslog, DNS, NTP/SNTP, SSH/SSL,
TFTP.
 Port Configuration
 Status, statistics, mirroring, rate limiting, event syslog
 Event Handling
 Event notification by Email: Cold/Warm Start, Power Failure, Authentication, SNMP
trap and Fault Alarm Relay Output