User manual

ENGLISH
START 16 Series | User manual
9
• Place the receiver in such a way that is far from a wall and that is at least
1 meter (about 3 feet) above the floor.
• Cell phones, two-way radio equipment or similar devices may disturb
the radio transmission between the transmitter and the receiver, so they
should not be used close to the transmission system.
4 | TROUBLESHOOTING
PROBLEM LEDS SOLUTION
No sound or very
low sound level.
Receiver ON/OFF
LED turned off.
Make sure the unit is properly
connected.
Power LED turned off.
Make sure the power supply is
properly connected to the receiver.
Receiver RF LED turned on.
Raise the volume.
Raise gain on transmitter.
Check the connections between
receiver and amplier or mixer.
Receiver RF LED turned on.
Transmitter LED turned on.
Don’t place the receiver close to
metallic objects.
Check that the transmission
space (“visual contact”) between
transmitter and receiver is free.
Approached the transmitter to the
receiver.
Make sure the transmitter and
receiver share the same frequency.
Batteries status LED is red. Replace batteries.
Distortion or unwanted
interferences.
Receiver RF LED
turned on.
Remove possible sources of
interference such as CD players,
computers, digital broadcast
sources, etc.
Increasing distortions.
Batteries status
LED is red.
Replace batteries.
Great intensity difference
when the same source
is via cable, or in case of
connection with other
guitars or microphones.
Set properly the transmitter gain
selector and the receiver volume.