Operation Manual

Fabrikant – Hersteller – Manufacturer – Fabrikant: ANSSEMS AANHANGWAGENS B.V. www.anssems.eu

Versie: GT-2

8. Mounting the steel railing

Your trailer can be equipped with a steel railing.

Following parts are deliverd in a set.

1. 2x Profile railing

2. 8x Railing uprights

3. 32x Rivets

4. 4x Plastic caps

Mounting goes as follows:

1. Bore the holes in the railing and the railing uprights with ø6.5mm. The parts are hot dip galvinized. Herewith you remove the remaining zinc.

2. Mount the railing uprights with the rivets to the railing. Please note that these are mounted at 90 degres.

Place the complete railing on the sideboard between the front cornerpièce and the upright profile at the backside. Adapt the holes of the

railing uprights and bore the holes in the side board. You can mount the railing with rivets and mount the plastic caps.