Operation Manual

Fabrikant – Hersteller – Manufacturer – Fabrikant: ANSSEMS AANHANGWAGENS B.V. www.anssems.eu
Versie: AMT-1
10
2.8 Winch
The winch is installed on an adjustable console. This
console is to be placed at two different locations in the
breadth direction in the front cross bar and in three
different positions in the longitudinal direction.
When the winch is not used it is possible to put the hook
of the winch trough the tie eye on the front beam. You
put the winch a little bit under pressure. With this there
is no tolerance between the console and the frame.
Scope of application
The winch is suitable for use as a trailer winch for the easy and shock-proof pulling of various loads. The maximum tractive force of the winch in the
lowest cable layer is 330 kg and 900 kg in the topmost cable layer. Only cables according to the regulations should be used.
Safety Information
Friction disk brake:
Minimum tractive force for perfect brake function: 25daN. If this minimum load does not exist the braking function does not take place!
Not approved for motor-driven operation!
Only touch the wire cables when wearing protective gloves!
The rope (belt) must only be wound up so far under load that a flanged wheel overhang of at least 1.5 x cable diameter is guarateed!
The cable must be wound round the drum an least twice under load!
Determine the fitting position so that when the winch is used the fleet angle is no more than 4˚.
Do not oil of grease the brake mechanism!
The cable winch must not be used for securing loads! (e.g. cars) Here the load requires separate lashing as the cable winch friction disk brake can be
loosened by vibration during the journey.
Operation
Lifting, pulling:
Turn the head crank clockwise.
Stopping:
The load can be stopped in any position by simply letting go of the crank.
Lowering:
Turn the cank anti-clockwise to lower the load. The automatic brake prevents the crand from kicking back (load pressure brake)
Attention:
The rope (belt) must only be wound up so far under load that a flanged wheel overhang of at least 1,5 x cable diameter is guarateed. This prevents the
winch from overload and stops the cable from running from the dum sideways. The cable must be wound rouend the drum at least twice under load.
Friction disk brake:
Minimum trative force for perfect brake function: 25daN. If this load does not exist the braking function does not take place! The cable (under load)
must be kept under slight tension for correct winding.
Maintenenance and cleaning