Instruction manual

 Balance Charger xMove 2.0 Deluxe 13
This program simply charges the battery using the current you set. In
’Aut’ mode, you need to set the upper limit of charge current to avoid
from higher feeding current that may damage the battery.
Because some batteries of low impedance and small capacity can
lead to a higher charge current by the processor at automatic charge
mode. But in ’Man’ mode, it will charge the battery with the charge
current you set at the display. Each mode can be switched by pressing
INC ► and ◄ DEC button simultaneously when the current field is
blinking.
The screen displays the current state of charging. To stop the process,
press “Batt type/Stop” key once.
The audible sound indicates you the end of process.
Battery
type
Elapsed
time
Charge
current
Battery
voltage
Charged
capacity
14. Charging NiCd/NiMH Batteries
13. NiMH/NiCd Battery Program
These programs are for charging or discharging NiMH (Nichel-Metal-
Hydride) or NiCd (Nickel-Cadmium) batteries commonly used for
R/C model applications. To alter the value at the display, press
“Start/Enter” key to make it blink then change the value using
INC ► or ◄ DEC key. The value will be stored by pressing
“Start/Enter” key once.
To start the process, press “Start/Enter” button for more than
3 seconds.
The processor monitors the voltage of individual cells during
’storage-mode’ and ’discharge’ of Lithium battery packs. It
tries to normalize the voltages to be equal. For this feature, the
individual plug of the battery pack should be connected to the
individual port of the charger.
If the voltage of any one or more cells varies abnormally during
the procedure, xMove 2.0 Deluxe terminates the process forcibly
with the error message. If this happens the battery pack contains
a bad cell, or a bad connection of the cable or plug. You can
easily know which of the cells is the bad one by pressing the
INC ► button at the time of showing the error message.
The processor found that the voltage of one of the cells in the
Lithium battery pack is too low.
In this case, the 4th cell is bad. If there happens a connection-
break of the cable or plug, the voltage value may show zero.
*Voltage balancing and monitoring during the discharge