Instruction manual

Instruction Manual12
You can set up the current and the voltage of the battery pack to be
charged. The current will be used for charge or discharge the battery
to reach the ’storage’ level of voltage.
The screen shows the present situation during charge process. To stop
charging press “Batt type/Stop” key once.
The value of discharge current on the left side of the screen may not
exceed 1C for a maximum safety and the final voltage on the right
should not be under the voltage level that is recommended by the
battery manufacturer to avoid deep discharging.
To start to discharge press “Start/Enter” key for more than 3 seconds.
(Discharge current: 0.1∼5.0 A)
This shows the present state of discharge. To stop discharging press
“Batt type/Stop” key once.
Number
of cells
Number
of cells
Elapsed
time
Elapsed
time
Charge or
discharge
current
Discharge
current
Current
voltage of
battery
Battery
voltage
Supplied
capacity
Discharged
capacity
12. Discharging Lithium Batteries
11. ’STORAGE’ Control Lithium Battery
This is for charging or discharging Lithium battery not to be used for
the time being. The program will determine to charge or discharge
the battery to the certain voltage depending on the voltage of the
battery at its initial stage.
They are different from the type of the battery, 3.75 V for Lilo,
3.85 V for LiPo and 3.3 V for LiFe per cell. If the voltage of the
battery at its initial stage is over the voltage level to storage, the
program will start to discharge.