Instruction manual

2s
3s
4s
5s
6s
7s
8s
Instruction Manual10
8. Charging Lithium Battery at
Balance Mode
This is for balancing the voltages of Lithium batteries of the battery
pack to be charged. To do this, the battery pack being charged should
have the individual cell connector. And connect it to the individual
port at the right side of the charger with a suitable connection cable
that fits with your battery pack. And also, you need to connect the
battery output plug to the output of charger.
In this mode, the charging process will be different from ordinary
charging mode. The internal processor of the charger will monitor the
voltages of each cell of the battery pack and controls the charging
current that is feeding to each cell to normalize the voltage.
The value on the left side of the second line sets a charge current and
the value on the right side of the second line sets the voltage of the
battery pack.
After setting the current and voltage press “Start/Enter” key for more
than 3 seconds to start the process.
(Charge current: 0.1∼7.0 A, Voltage: 1∼8 series)
This shows the number of cells you set up and the processor detects.
’R:’ shows the number of cells found by the charger and ’S:’ is
the number of cells selected by you at the previous screen. If both
numbers are identical you can start charging by press “Start/Enter”
button. If not, press “Batt type/Stop” button to go back to the
previous screen. Then carefully check the number of cells of the
battery pack to charge again.
The screen shows the present situation during charge process. To stop
charging press “Batt type/Stop” key once.
9. Individual Cell Connection Diagram
(Pin-Assignment of 9-Pin)
Number
of cells
Charging
time
Charge
current
Charged
capacity
Battery
voltage
Individual
bal. port
Individual
bal. port