Operation Manual

CENTRE THE BRAKING SHOE

The centre screw is for fine adjustment. Read just the braking shoe distance by using

the wire setting screw.

V-BRAKE

1. Push the braking block against the rim and tighten the brake shoe fixing screw.

2. Pull the wire through the cable casing.

3. Set the distance between the brake shoe at the left and the right side to 2mm. Fix

the wire fixing screw.

4. Before using the brake, pull the brake lever to the handlebar approx. 10 times and

check that it is working properly.

CHANGE BRAKE PADS

1. Remove the locking pin from the brake shoe

2. Push the brake pad out of the brake shoe.

3. Make sure that different brake pads are used on the left and the right side

4. Push the new brake pad into the brake shoe mounting and pay attention that the

direction and the holes for the locking pins are correct.

5. It is important to insert the locking pin to fix the brake pads correctly

DISC BRAKES

Bicycles with disc brakes are delivered with a separate manufacturer’s manual for the

brakes. Please read this manual and adhere to its recommendations.

Disc brakes achieve their full potential after approx. 30-100 braking processes, the

same as with motorised vehicles.

R55C2

FORWARD