Instruction Manual

EN
12
PRODUCT INFORMATION SHEET
Supplier’s name or trademark: Anslut
Supplier’s address (
a
): Jula AB, Julagatan, 2, 53237 Skara, SE
Model identier: 019942
Type of light source:
Lighting technology used: LED Non-directional or directional: NDLS
Light source connected to mains supply or
light source not connected to mains supply:
MLS Connected light source (CLS): no
Colour-tuneable light source: no Envelope: -
High luminance light source: no
Anti-glare shield: no Dimmable: yes
Product parameters
Parameter Value Parameter Value
General product parameters:
Energy consumption in on-mode (kWh/1000 h) 15 Energy eciency class E
Useful luminous ux (Φ
use
), indicating if it
refers to the ux in a sphere (360˚), in a wide
cone (120˚) or in a narrow cone (90˚).
1 600 in
Sphere (360°)
Correlated colour temperature, rounded to
the nearest 100 K, or the range of correlated
colour temperatures, rounded to the
nearest 100 K, that can be set.
3 000
On-mode power (P
on
), expressed in W. 14,5
Standby power (P
sb
), expressed in W and
rounded to the second decimal.
0,00
Networked standby power (P
net
) for CLS,
expressed in W and rounded to the second
decimal.
-
Colour rendering index, rounded to the
nearest integer, or the range of CRI-values
that can be set.
80
Outer dimensions without
separate control gear, lighting
control parts and non-lighting
control parts, if any (millimetre).
Height 294
Spectral power distribution in the range
250 nm to 800 nm, at full-load.
See image
in last page
Width 294
Depth 23
Claim of equivalent power (
c
) - If yes, equivalent power (W) -
Chromaticity coordinates (x and y)
0,434
0,403
Parameters for directional light sources:
Peak luminous intensity (cd)
Beam angle in degrees, or the range of
beam angles that can be set
Parameters for LED and OLED light sources:
R9 colour rendering index value 0 Survival factor 0,90
The lumen maintenance factor 0,96
Parameters for LED and OLED mains light sources:
Displacement factor (cos φ1) 0,90 Colour consistency in mcadam ellipses 6
Claims that an LED light source replaces a
uorescent light source without integrated
ballast of a particular wattage.
-
(b)
If yes then replacement claim (W) -
Flicker metric (Pst LM) 1,0 Stroboscopic eect metric (SVM) 0,4
(a)”-”: not applicable;
(b)”-”: not applicable;
INSTALLATION
FIG. 1–8