Instruction Manual

EN
11
necessary experience and knowledge
(otherwise contact an electrician), you can
replace power switches and wall sockets,
t plugs, extension cords and light sockets.
Incorrect installation can result in fatal injury
and the risk of re.
Symbols
Read the instructions.
Safety class II.
It can be only for indoor use.
Approved in accordance with
the relevant directives.
WARNING: Risk of electric
shock.
Recycle end-of-life product
in accordance with local
regulations.
TECHNICAL DATA
Rated voltage 230 V
~
50 Hz
Output 14.5 W
Luminous ux 1600 lm
Colour temperature 3000 K
Life span 30000 h
O/On 30 000 times
Energy class E
Dimmable Yes
Safety class II
Protection rating IP54
Diusion angle 120°
Size Ø 294 x 23 mm
SAFETY INSTRUCTIONS
• It can be only for indoor use.
• The light source of this luminaire is not
replaceable; when the light source
reaches its end of life the whole luminaire
shall be replaced.
• Always disconnect from the power supply
before installation, connection and
service.
• Do not connect the product to the mains
while it is still in the pack.
• Check that all connecting cables comply
with the applicable regulations and that
they are connected correctly.
• Check that the mains voltage corresponds
to the rated voltage on the type plate.
Incorrect connection can result in a risk of
electric shock. The electrical installation
should be carried out by an authorised
electrician.
• Never modify the product, this could result
in serious personal injury and will
invalidate the warranty.
• Never overload the mains. This can result
in re or a risk of electric shock.
• Keep out of the reach of children.
• Do not store the product in a damp or
very cold/hot place to avoid damaging
the electronics.
• The electronics in the product are sensitive
to knocks and blows.
• Never attempt to replace damaged power
cords yourself.
• The product must be discarded if the glass
front is cracked.
• The LED light source is not replaceable.
When the light source has reached the
end of its useful life the complete product
must be replaced.
WARNING!
New installations and extensions to existing
systems should always be carried out by
an authorised electrician. If you have the