Instruction Manual

EN
14
WARNING!
New installations and extensions to existing
systems must always be carried out by
an authorised electrician. If you have the
necessary experience and knowledge
(otherwise contact an electrician), you can
replace power switches and wall sockets,
t plugs, extension cords and light sockets.
Incorrect installation can result in fatal injury
and the risk of re.
SYMBOLS
Read the instructions.
Safety class II
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.
TECHNICAL DATA
Voltage 230 V ~ 50 Hz
Output 13.5 W
Luminous ux 1500 lm 360°
Colour temperature 6500 K
Life span 15,000h
Colour rendering index 80
Energy class (A - G) E
Dimensions L1000 x W62 x H36 mm
MOUNTING
1. Insert the expansion plugs for M4 screws
into the ceiling or wall.
2. Using M4 screws, secure the bracket to the
ceiling or wall.
SAFETY INSTRUCTIONS
Read these instructions before use and save
them for future reference.
• For indoor use only.
• Disconnect the power supply before
installation.
• Check that the rated voltage corresponds
to the mains supply voltage.
• Do not connect the product to the mains
while it is still in the pack.
• Check that all electrical cables comply
with the applicable regulations and that
they are connected in accordance with the
instructions. Never attempt to replace
damaged electrical cables yourself.
• Never overload the mains. This can result
in re or a risk of electric shock.
• Keep out of the reach of children.
• Do not store the product in a very cold/
hot place to avoid damaging the
electronics.
• The electronics in the product are sensitive
to knocks and blows. Avoid dropping it.
• The light source is not replaceable. If the
light source stops working the product
must be discarded.
• The product is not dimmable.
• Take care to avoid damaging any
concealed wiring and pipes during
installation.
• Be careful not to damage the insulation
on the wires during installation. Make
sure that the wires do not come into
contact with sharp edges. Damaged
insulation can result in a risk of electric
shock.
• Do not look directly into the light source.
• The product can be installed in
environments where an accumulation of
conductive dust may be expected. In these
environments, the electrical connection
must comply with EN 60364-4-42