Instruction Manual

EN
15
5. Pierce a hole through the rubber cable
grommet using a screwdriver, for
example, and insert the cable from the
rear.
FIG. 5
6. Screw the mounting plate to the wall
using a Phillips screwdriver.
FIG. 6
7. Remove the 2 screws and the strain
reliever.
FIG. 7
8. Connect the cable wires correctly to the
terminals on the mounting plate as
indicated.
FIG. 8
9. Lock the cable with the strain reliever and
the 2 screws.
FIG. 9
10. Place the product on the mounting plate
ensuring it is straight. Depress the lock
button and press the product against
the wall until the lock button clicks into
place in the casing. Insert the screws
from below, through the casing into
the mounting plate, and tighten with a
Phillips screwdriver.
FIG. 10
11. Switch on the power supply.
FIG. 11
USE
The product has the following 4 modes. To see
which mode has been selected, press on the
mode button.
1. Night mode with light and rotation (ashes
once)
2. Day and night mode with light and
rotation (ashes twice)
3. Night mode with light without rotation
(ashes 3 times)
4. Day and night mode with light without
rotation (ashes 4 times)
When the light is powered on, it rotates as a
self test and defaults to mode 1.
When selecting a new mode, the change will
take eect after the rotation has completed.
MAINTENANCE
RECYCLING
Light source
Recycle end-of-life product in accordance with
local regulations. The light source should
be removed from the lamp and recycled
separately.
FIG. 12
FIG. 13
FIG. 14
Actuator
FIG. 15
FIG. 16
FIG. 17