Instruction Manual

EN
14
TECHNICAL DATA
Voltage 230 V
~
50 Hz
Output 18 W
Colour temperature 4000 K
Luminous ux 1408 lm
Protection rating IP44
Size 170 x 183 x 207 mm
ASSEMBLY
WARNING!
Check that the mains supply is disconnected
before starting installation.
WALL BRACKET POSITIONING
The ideal height for the bracket is approx.
2.5 m.
To prevent incorrect activation, place the
product away from radiators, climate
control units and other sources of heat.
Place the product so that the PIR sensor is
not exposed to direct light as this may
cause the product to malfunction.
Make sure the product is not exposed to
strong electromagnetic elds.
ASSEMBLY
1. Switch o the power supply.
FIG. 1
2. Remove the mounting plate from the
product using a Phillips screwdriver.
FIG. 2
3. Depress the lock button on the mounting
plate and pull the plate out of the
product’s casing using the ribbon.
FIG. 3
4. Drill holes through the punched fastening
holes, mark their position on the wall and
drill the holes in the wall. Insert wall plugs
into the holes.
FIG. 4
SAFETY INSTRUCTIONS
The power cord cannot be replaced.
The whole product must be replaced
if the cord is damaged.
The product must be connected to an
earthed power point.
Regularly check all electrical connections
and power cords for damage. Any faults
must be rectied before using the
product. Always have the wiring and
connections checked by an authorised
electrician.
Check that the mains voltage is the same
as the power supply voltage stated on the
type identication plate.
Do not use the product if the glass cover is
cracked or damaged. The product must be
discarded if the glass cover is cracked or
damaged.
The light source is not replaceable.
The entire product must be replaced
if it stops working.
SYMBOLS
Read the instructions.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.
Warning: Risk of electric shock.
Non-replaceable
actuator.
Non-replaceable light
source.