User manual

6. Installations & SIP Configurations
1. Connect VS211 RJ45 WAN port to NAT Router using a Category 5 LAN cable.
2. Connect VS211 RJ45 LAN port to Notebook PC using a Category 5 LAN cable.
3. Connect VS211 RJ11 PHONE port to a Plain Old Telephone Set (POTS).
4. Connect VS211 RJ11 LINE port to a Public Switched Telephone Network (PSTN) line.
5. Connect the power adaptor (12VDC) to power on VS211, and the POWER LED will be ON.
6. The PHONE LED indicators will be OFF for about 5 seconds and start flashing for 5 times,
and remain OFF for VoIP configurations. The LAN LED will be ON when RJ45 Ethernet
ports are connected. Pick up the phone, and the PHONE LED will be Green ON indicating
VoIP mode. If you hear a busy tone, please check if the WAN port is connected.
7. Press 0* key to PSTN line. The PHONE LED will become Yellow ON and you should hear a
PSTN dial tone. If not, please check if the PSTN Line is connected.
8. Press #120# to check the assigned IP address for the VS211. The default IP address is
192.168.123.1. Please refer to Chapter 8, and you may enter this IP address in IE Web
browser for web configurations.
9. Register VS211 into your SIP server, and refer to Chapter 10 for VoIP applications examples
of SIP registrations.
10. If VS211 has successfully registered in the SIP server, the PHONE LED will start Green
flashing.
11. Pick up the phone, a nd you should hear a dial tone. Press 123456# to call the party with the
number 123456 registered in the SIP server. Note that # will dial out the number immediately.
Dialing without # will not dial out until the auto dial timer (default=5 seconds) elapsed. In a
moment, you should hear a ring back tone, and wait for answer.
7. Default Reset by Telephone
VS211 provides an easy way to reset to factory defaults by using Telephone.
Pick up the phone and press #198# to reset back to factory defaults, and the VS211 will enter
into POWER ON cycle. The PHONE LED indicators will be OFF for about 4 seconds and start
flashing for 5 times. The POWER LED then will be lit constantly, and the PHONE LED will be
OFF.
3