User manual

9. Configurations by Telephone & IVR
You can use telephone to configure and to check the status of VS211. Make sure that the LAN
port is connected to Ethernet, or you may hear a busy tone from the telephone.
Group IVR Action Phone Command Remarks
Status Check TA LAN IP Address
#120#
IVR will report the current TA local
IP
address. Hang up while hearing end tone.
Status Check IP Type
#121#
IVR will report if WAN
DHCP in enabled or
disabled. Hang up while hearing end tone.
Status Check Phone Number
#122#
IVR will report registered phone number.
Status Check Network Mask
#123#
IVR will report WAN network mask.
Status Check Gateway IP Address
#124#
IVR will report WAN Gateway IP address.
Status
Check Primary DNS Server
IP Address
#125#
IVR will report WAN Primary DNS
Server IP
address.
Status Check TA WAN IP Address
#126#
IVR will report the TA WAN IP address.
Status Check Firmware Version
#128#
IVR will announce the firmware version.
Setting Set WAN DHCP client
#111#
This set WAN to DHCP Client mode.
Setting Set WAN Static IP Address
#112xxx*xxx*xxx*xxx#
Ex: #112061*066*159*009#
Note xxx must be 3 decimal digits.
This setting will disable DHCP Client.
Setting Set WAN Network Mask
#113xxx*xxx*xxx*xxx#
Ex: #113255*255*255*000#
Note xxx must be 3 decimal digits and
Must set WAN Static IP first (#112).
Setting Set Router IP Address
#114xxx*xxx*xxx*xxx#
Ex: #114061*066*159*254#
Note xxx must be 3 decimal digits and
Must set WAN Static IP first (#112).
Setting Set Primary DNS Server
#115xxx*xxx*xxx*xxx#
Ex: #115159*168*001*001#
Note xxx must be 3 decimal digits and
Must set WAN Static IP first (#112).
Setting Set Codec
#130+[1-8]#
1:G.711 u-Law, 2: G.711 a-Law,
3: G.723.1, 4: G.729a,
5: G.726-16K, 6: G.726-24K,
7: G.726-32K, 8: G.726-40K.
Setting Set Handset Gain
#131+[00~15]# Ex: #13107# and default is 06
Setting Set Handset Volume
#132+[00~12]# Ex: #13209# and Default is 10
Setting
Set TFTP Server
IP Address
#135xxx*xxx*xxx*xxx# Ex: #135061*066*159*254#
Setting
Set FTP Server
IP Address
#136xxx*xxx*xxx*xxx# Ex: #136159*168*001*001#
Setting Auto Configure Mode
#137+[0~2]# 0: Disable, 1: TFTP mode 2: FTP mode
33