User manual

WAN Settings:

8.43. The WAN setting is used to configure the Ethernet port connects to the ADSL Modem/Router.

8.44. The default setting is for NAT mode to enable the embedded NAT router between the WAN

port and LAN port. You may select Bridge Mode if you need NOT use the embedded NAT

router. When setting to Bridge Mode, only the WAN settings will get effective and the LAN

settings will be ignored.

8.45. There are three selections for WAN IP Type: Fixed IP, DHCP Client, and PPPoE modes. This

WAN setting is for the WAN port when set in NAT mode. The default is at DHCP Client.

8.46. For Fix IP Mode, please make sure the IP address. Net Mask, Gateway, and DNS settings

are suitable in your current network environment.

8.47. For PPPoE Mode, you have to enter correct username and password to get the IP address

from your Internet Service Provider.

8.48. When you finished the settings, please click the Submit button.