Installation guide

Note 1: If no IP address is assigned within 30 seconds, the networked device will

automatically assign 192.168.0.100. User may now open your web browser, and key in

http://192.168.0.100

in the address bar of you web browser to logon Network Camera’s

web configuration page.

Note 2: Power Line Frequency

- If you found the video image is flash, you may need to choose 50 or 60 Hz frequency

(depends on country).

- World wide power line frequency table is inside user’s manual, Appendix

Note 3: If you have problem when connecting the network camera to a router, please read

user’s manual inside CD, the section “Installation to a router”.

After connected to networked device, the device will prompt for User name and Password.

For the first time, please enter: admin as username and no password to continue Web

Management.

If difficulty is met, please refer to the following steps to establish the connection:

- The networked device must be installed and powered ON.

- If the networked device’s default IP Address (192.168.0.100) is already used by another device,

the other device must be turned OFF until the device is allocated a new IP Address during

configuration.

Made in Taiwan