Installation guide

3. Set the proper image by moving the camera body (3-axis) and set the focus by

turning the lens to the left or right direction.

4. When the camera focus adjustment has been completed, use the provided L-wrench

to fasten the vandal-resistant housing to the main body.

5. When using the side conduit cabling, it is suggested to cover the cables using metal

covers (to prevent external damage and for waterproof prevention), and wined the

waterproof adhesive tape (P.T.F.E. THREAD SEAL TAPE) onto the metal cover before

installation.

6. Connect the LAN cable to Ethernet’s switch or hub, the video cable to video output

to the monitor or other video device through a 75 Ohms type coaxial cable and the

DC-Jack to the power source.

7. Vari-Focal Dome Operation Guide: Once the picture appears on the monitor, open

the cover and adjust the lens wrench to “NEAR←→FAR”, get the view zoom that you

desire, and then adjust the focus wrench of the lens to obtain the best picture. After

adjustment, tighten both wrenches.

oom

Adj

ustment

Focal Adjustmen

NEAR

FAR

WIDE

TELE

8. Connect the necessary cables and connectors: