User's Manual

 
$$ Ensure$that$the$rifle$is$unloaded$before$and$after$use$or$during$maintenance$and$cleaning.
 
$$ Firearms$may$only$be$transported$in$an$unloaded$condition$and$in$locked$containers.$
$$ When$you$are$putting$your$rifle$in$a$case$or$a$soft$case,$always$make$sure$that$the$rifle$
and$the$inside$of$the$case$or$soft$case$are$dry$and$that$no$water$or$moisture$remains.
$$ Only$ever$put$a$cleaned,$dry$and$oiled$rifle$in$your$case$or$soft$case.
$$ Always$place$the$rifle$in$the$transport$case$with$the$sight$facing$upwards$$
(towards$the$handle).$This$protects$the$rear$sight$from$impacts$and$also$protects$$
the$rear$sight$setting$screws$as$a$result.
 
$$ Firearms$that$are$not$in$use$must$be$kept$in$a$secure$place$under$lock$and$key.
$$ Firearms$must$always$be$stored$in$an$unloaded$and$uncocked$condition.
$$ Ammunition$must$be$kept$in$a$separate$place$under$lock$and$key.
 
For your own safety, approved hearing and eye
protection should be used when shooting!
Shooting without safety equipment can result in
da-mage to your hearing and sight.

 
When using compressed air cartridges please
always observe the manufacturer's instructions!

$$ The$fill$level$indicator$of$the$compressed$air$cylinder$may$only$be$checked$when$the$
compressed$air$rifle$is$unloaded$and$uncocked.
$$ The$fill$level$indicator$of$the$compressed$air$cylinder$must$not$be$checked$during$re-filling.
Design aspects mean that the fill level indicator
operates with an accuracy of ± 10%. Temperature
influences mean that there can also be deviations
in the fill level indicator.

$$ Full$compressed$air$cylinders$must$not$be$exposed$to$temperatures$below$-20°C$or$$
above$70°C$(when$transporting$and$storing$them,$adequate$insulation$must$be$provided,$$
e.g.$by$storing$in$expanded$polystyrene$packaging$or$in$a$gun$case).
$$ In$aircraft,$when$sending$by$post,$etc.$the$compressed$air$cylinders$must$always$$
be$unfilled.
$$ After$approx.$20$fillings,$the$compressed$air$cylinder$must$be$emptied$slowly$and$$
completely$in$order$to$allow$any$condensed$water$to$escape.
$$ When$screwing$on$or$off$the$compressed$air$cylinder$or$when$refilling$it,$always$stand$side$
on$in$relation$to$the$cylinder$and$ensure$that$no$other$person$is$in$the$vicinity$of$the$end$of$
the$cylinder$(where$the$manometer$is$positioned).