User's Manual
X Make sure that the safety catch is released.
) If the trigger stop setting screw [T] is screwed in too far by a
few turns:
X Screw the trigger stop setting screw [T] to the left by a few turns
until the cocking piston or the firing pin actuates again when the
trigger is actuated.
The setting screw [L] (first stage) is screwed in too far by a few turns.
X Screw the setting screw [L] to the left by a few turns, until the trigger
catches the cocking lever or the firing pin again.
X Then set the desired first stage travel.
X Check that the tension spring [1] is undamaged and is hooked in
correctly.
Setting screw [C], sear engagement, has been turned:
X Turn the setting screw [C] by approx. 1 turn to the left.
X Cock the weapon, turn the screw [C] to the right until the weapon
discharges. Then turn back by
1
/
5
of a turn.
The trigger function must be checked after every
change. When the fault is eliminated, check the
desired trigger values and reset them if necessary.
This procedure is used to reset all settings on the
trigger. With this starting setting, the trigger can
then be individually adjusted again.
X Remove the action from the stock.
X Set the adjusting screw [T] so that the head of the screw is flush
with the trigger housing surface [5].
X Set the adjusting screw [L] so that the trigger sear [7] is horizontal.
X Cock the action.
X Set the trigger using the relevant adjustment screws to give the
individual settings desired.