User's Manual
The setting screws B and C are pre-set and sealed
in the factory. Setting or modification using these
screws is prohibited.
Setting the trigger weight using the setting screw F2
(setting range from 50 g to 170 g):
y turn clockwise = trigger weight is increased (+)
y turn anticlockwise = trigger weight is reduced (–)
Setting the first stage pull using the setting screw F1:
y turn clockwise = first stage weight is increased (+)
y turn anticlockwise = first stage weight is reduced (–)
The sear engagement denotes the travel from the second stage to the
release of the trigger. The sear engagement is set in the factory to an
optimum value.
Danger to life!
Unintentional discharge as a result of too short a sear
engagement and/or too low a trigger weight.
h Do not set the sear engagement too short.
h Do not set the trigger weight too low.
h Do not subject loaded and unsecured rifles to
impact and do not use force to close the breech.
First stage travel denotes the travel of the trigger blade from the
zero position to the second stage.
Setting the first stage travel using setting screw [L]:
y turn clockwise = first stage travel is shortened
y turn anticlockwise = first stage travel is lengthened