User's Manual
X Remove the compressed air cylinder (see Chapter 17.2).
X Remove the screws [3a] and [3b] on the end of the support
and remove the upper section of the support.
X Release the screws [1a] and [1b] at the side, then remove the
action carrier.
X Place the action carrier in position on the action.
X Tighten the screws [1a] and [1b] at the side of the action carrier.
X Screw the compressed air cylinder in
X Tighten the screws [2a] and [2b], ensuring the clamping piece
is not under tension.
X Tighten the screws [3a] and [3b] after fitting the support.
X Make sure that the screws are tight.
[2]
[3]
[3]
[2]
Fig. 3a Removing the action carrier
[1a]/[1b]
[2a]/[2b]
[3a]/[3b]
Fig. 3b Model 9003 Precise
X Remove the compressed air cylinder (see Chapter 17.2).
X Release screws [1a], [1b], [2a] and [2b].
X Slide the support [3] towards the muzzle.
X Remove action carrier [5] from action [4].
X Fitting is carried out in the reverse sequence.
[1a]/[1b]
[2a]/[2b]
[4]
[3][5]
Fig. 3c Model 9003 Premium