User's Manual
Fixing to the support:
X Insert or replace the long (hard or soft) Soft-Link
®
elements [A]
on both sides (2 in number).
X Fitting the action is carried out in reverse order.
When using the soft Soft-Link
®
elements, before
fitting the screws, the flanged bushes [B] must be
fitted from the outside into the Soft-Link
®
chamber
at position [1]. Then the screws must be fitted and
tightened on both sides at position [1].
[4]
[C]
[1] [5]
[3]
[2]
[C]
[B]
[B]
[A]
[A]
Fig. 2 Soft-Link
®
X Remove the compressed air cylinder (see Chapter 17.2).
X Remove the screws [a] on the end of the support [5].
X Release the screws [b] on the support fixing.
X Remove the bedding screws [c] on the forend [6].
X Remove the forend [6].
X Remove the bedding screw [d] in the aluminium stock
(in front of the trigger).
X Pull the support [5] from the aluminium stock until the mechanical
connection releases.
X Remove aluminium stock from action (the vibration-absorbing
elastomer in the action bed is now loose).
X Fitting is carried out in the reverse sequence.
[c] [c]
[a]
[d]
[b]
[5]
[6]
Fig. 3 Removing the aluminium stock