Manual

23
Unloading
For safety reasons the rifle must immediately
be unloaded if you intend to stop shooting.
Unlock and open the bolt. This will eject
the cartridge. Please also see safety
instructions for the handling of rifles and
pistols.
Cocking, loading and safety
operation
•Degrease the bolt and the interior of the
barrel without leaving lint.
•Open the bolt and pull it back to the stop.
Carefully insert an approved cartridge
with the bullet forward with the thumb into
the chamber. Make sure that the bullet is
not damaged.
•Now push the bolt forward to close the
breech and ensure that the bolt handle is
pushed completely downwards to lock it.
The bolt is now locked and cocked.
•After firing, lift the bolt handle and pull
the bolt fully to the rear. This will cock
the bolt again and eject the empty case.
The safety is located on the left-hand side
of the receiver. It can be operated in cocked
position.
The rifle is:
•safe, when the „S“ (safe) is visible but the
„F“ (fire) is covered
•ready for shooting when the „F“ (fire) is
visible but the „S“ (safe) is covered.
Bolt
To disassemble the bolt:
•Depress the bolt stop at the left hand side
of the receiver (procedure with true left
hand rifles vice-versa) and keep it pressed
until the bolt is completely removed from
the receiver.
•For disassembling, unlock the bolt by
rotating the bolt handle clockwise (for left-
handed bolts counter-clockwise). The red
signal pin protruding at the end of the
cocked bolt will disappear into the cap.
•Unscrew the cap. Attention: During the
first twists you can hear a ratcheting
sound.
•The firing pin and the associated parts of
the bolt may be removed now one after
the other.
•To remove the firing pin spring from the
firing pin push back the front spring
support until it stops and twist it slightly to
the right or the left (approx. 1/4 turn).
You can now easily remove the spring
support together with the spring by pulling
it forward.
To reassemble the bolt:
Note: the sequence and position of the
parts can be seen from the drawing.
•First push back the firing pin spring then
the front spring support over the firing pin.
Push back the spring support until it stops
and lock by twisting it slightly either
clockwise or counter-clockwise (approx.
1/4 turn).
•Hold the bolt body perpendicular to the
ground. Slide the bolt handle with its wide
front surface to the front onto the end of
exchange the barrel, this must be carried
out by ANSCHÜTZ only. If the red seals
are damaged any claims for liability and
warranty become obsolete.