Manual

31
they may have a detrimental influence on
the performance of your rifle.
•Loosen the clamping screws.
•Pull off the muzzle tube in the direction of
shooting. Once removed the muzzle tube
has to be cleaned with cleaning device
4422/1 (Order No. 710.6350). Any
residue must then be removed.
•Carefully clean the muzzle with a slightly
oiled lint-free cloth.
•Following this the tube is refixed to the
barrel so that the groove in the tube is
coupled with the fixing pin on the barrel.
• Afterwards the clamping screws must be
tightened with a torque of 5.5 Nm
(55 cmkp).
Maintenance of the trigger:
•Lubricate the bearings slightly with cold
resistant molybdenum disulphide grease
once a year.
•Spot a small amount of oil into the bearing
parts using a needle.
•The internal parts should not be washed
with spray or oil to avoid resin or other
residues in the trigger.
Attention:
When cleaning the rifle no dirt, residues of
solvents, grease or non-suitable oils must get
into the trigger mechanism. We therefore
recommend either to use our cleaning rod
guide or to clean your gun in a way that it
is horizontal or even with the stock up to
avoid any contamination of the trigger
mechanism.
Protect your rifle against dust, sand,
humidity, heat and other harmful influences.
Vacuum clean your gun case or soft gun
case once a month to remove dust and lint.
Gun cases and soft gun cases should have
a smooth and dust rejecting inner lining.
Be aware that condensed water might
occur as a result of temperature variations.
In such a case it has to be removed at once.
Leave your gun case or soft gun case open
when you store them at home so that
possible humidity can escape.
Adding a humidity absorber reduces the
development of humidity. Be aware of other
possible changes or damage. In such a
case take your rifle to an authorized
gunsmith for checking or send it to our
factory.
To reduce the risk of damage in transit, we
recommend the disassembly of the barreled
action from the stock.