Manual

28
i
r
et
uo
pa sd f
•The trigger stop set screw No. 8 is
screwed in too much. Turn it a few turns
to the left until the cocking piston or firing
pin will release again.
The trigger does not catch the cocking
piston or firing pin:
•Set screw No. 4 (first stage) is screwed in
too much.
•Check to see if the spring is correctly
attached and not defective.
The first stage trigger is adjusted too
tightly:
•Turn set screw No. 5 stepwise
1
/
4
turn to
the right until the firing pin is caught.
Catch rebound spring is too weak or
defective:
•Send your trigger to the factory or your
service center for inspection.
10. Safety:
On the left side of the trigger there is a
safety lever. Please see chapter „Cocking,
loading and safety operation“.
11. Maintenance:
Please see chapter „Cleaning, mainte-
nance, care, lubrication“.
Important note:
To protect your highly accurate trigger and
to maintain perfect functioning always close
the bolt carefully.
Attention:
If you change the trigger remove the bolt
from the receiver when fitting the trigger as
otherwise the trigger will be damaged.