Manual

2524
It is only possible to remove a pellet from
the action by firing it off which should only
be done by firing it into a bullet trap.
Observe the safety regulations with regard
to the safe handling of rifles.
i
r
et
uo
p
as
d
f
Trigger
Warning:
Your ANSCHÜTZ target rifle offers you a
versatility of individual adjusting properties.
Please make sure that your rifle always is
unloaded when carrying out adjustments.
1. Trigger weight
Adjust the trigger weight with set screw
No. 10 (silver screw):
•if you turn it to the right:
trigger weight is increased (+)
•if you turn it to the left:
trigger weight is decreased (-)
Trigger weight and first stage weight
depend on each other with regard to the
mechanic mechanism. If one of them is
changed there will always be a corres-
ponding change of the other as well.
Remove the compressed air cylinder before
storing your rifle (also see chapter
”Compressed Air Cylinder/Handling”!).
Only use diabolo pellets in the caliber of
your air rifle, no bolts or other foreign
materials.
The stock and the barreled action are
packed separately for shipment and need
to be assembled. However, do not do this
until you have followed all the procedures
listed below.
•Wipe away excess surface oil
•Insert the barreled action into the stock
•Screw in bedding screws (two) with
enclosed Allen wrench Model No. 4406
(Order No. 710.6301) and tighten them
alternately and uniformly. For correct
adjustments we recommend our torque
wrench model No. 4405 (Order No.
700.6180), which is to be adjusted to
5 Nm (= 50 cmkp) for wood stocks and
to 6 Nm (60 cmkp) for aluminum stocks.
•Pull a cleaning patch through the barrel
from the chamber towards the muzzle.
•to cock the cocking piston lift the loading
lever and pull it backwards until it is
vertical.
•to load push the diabolo pellet with its
flat head flush with the front of the loading
platform.
•to lock the breech press the lever forward
and down until you feel that it locked into
position.
•the signal pin at the end of the action
indicates that the rifle (with filled
compressed air cylinder) is ready for
shooting.
The lateral safety lever can be operated
when the rifle is cocked.
The rifle is
•safe, when the ”S“ (safe) is visible but the
”F“ (fire) is covered
•ready for shooting when the ”F“ (fire) is
visible but the ”S“ (safe) is covered.
Attention:
The safety lever must latch properly so that
the ”F“ is covered in the ”safe“ position and
the ”S“ is covered in the ”fire“ position. The
lever must never be situated between the two.
Do not store the rifle when it is cocked.
Caliber: 4.5 mm
Barrel length: 64 cm/26.2"
Junior: 53cm/20.8"
Rifling: 42 cm/16.5"
Total length: 108 cm/42.5"
Junior: 88cm/34.6"
Sighting line: 77 cm/30.3"
Junior: 66 cm/25.9"
Weight: 4.6 kg/10.1 lbs
Junior: 3.6 kg/7.9 lbs
Version: Single loader
After the first assembly there might be a
warping of the wood. We would therefore
recommend to loosen and tighten the
bedding screws again after some time.
Check the tight fit of the screws before every
shooting.
Match Air Rifles 2002
Compressed Air, 2002
Compressed Air Junior
Technical Data:
Assembly, fitting the
ANSCHÜTZ barreled action
Cocking, loading and safety
operation
Unloading
Trigger adjustments