Manual

25
After assembly for the first time large
settlements of the stock wood may occur.
Consequently we suggest that you tighten
the screws once more in the manner
described after some time. Check the the
screws before every shooting.
signal pin is visible
= cocked
uncocked
signal pin
Cocking, loading and safety
operation
•Degrease the bolt and the interior of the
barrel without leaving lint.
•Open the bolt and pull it back to the stop.
Carefully insert an approved cartridge
with the bullet forward with the thumb into
the chamber. Make sure that the bullet is
not damaged.
•Now push the bolt forward to close the
breech and ensure that the bolt handle is
pushed completely downwards to lock
it. The bolt is now locked and cocked.
•After firing, lift the bolt handle and pull
the bolt fully to the rear. This will cock
the bolt again and eject the empty case.
The safety is located on the left-hand side
of the receiver. It can be operated in
cocked position.
The rifle is
•safe, when the „S“ (safe) is visible but the
„F“ (fire) is covered
•ready for shooting when the „F“ (fire) is
visible but the „S“ (safe) is covered.
Unloading
For safety reasons the rifle must
immediately be unloaded if you intend to
stop shooting. Unlock and open the bolt.
This will eject the cartridge. Please also see
safety instructions for the handling of rifles
and pistols.
Bolt
To disassemble the bolt
•Depress the bolt stop at the left hand side
of the receiver (procedure with true left
hand rifles vice-versa) and keep it pressed
until the bolt is completely removed from
the receiver.
•For disassembling, unlock the bolt by
rotating the bolt handle clockwise (for left-
handed bolts counter-clockwise). The red
signal pin protruding at the end of the
cocked bolt will disappear into the cap.
•Unscrew the cap. Attention: During the
first twists you can hear a ratcheting sound.
•The firing pin and the associated parts of
the bolt may be removed now one after
the other.
•To remove the firing pin spring from the
firing pin push back the front spring
support until it stops and twist it slightly to
the right or the left (approx. 1/4 turn).