Manual

KK-Biathlon
Small bore target rifle
Mod. 1827 ANSCHUTZ Fortner
Technical Data:
1827 ANSCHUTZ Fortner
Caliber: .22 I.r.
Barrel length: 55 cm / 21.6"
Rifling: 55 cm / 21.6"
Total length: 104 cm / 40.9"
Totallength
barreled action:
Weight approx.:
Version:
73 cm / 28.7"
4,0 kg
/ 8.8 Ibs
Repeater
1827 ANSCHUTZ Fortner Sprint nitride
Caliber: .22 I.r.
Barrel length: 55 cm / 21.6"
Rifling: 55 cm / 21.6"
Totallength: 104 cm / 40.9"
Totallength
barreled action:
Weight approx.:
Version:
73 cm / 28,7"
3,7 kg
/ 8.2 Ibs
Repeater
Assembly, fitting the
ANSCHUTZ barreled action
The stock and the barreled action are
packed separately for shipment and need
to be assembled. However, do not do this
until you have followed all the procedures
listed below.
.Wipe away excess oil from the surface
of the barreled action.
.Remove the magazine and the two screws.
.Insert the barreled action into the barrel
channel in the stock. To do this the groove
24
at the bottom of the receiver must be
attached to the iron abutment of the stock.
The receiver must not touch the abutment,
however.
.Screw in the bedding screws with the
enclosed screw driver and tighten uniformly
step by step.
For a correct adjustmentwe recommend to
use the torque wrench Model No. 4405
(Item No. 7006180). which is to be
adjusted to 5 Nm (50 cmkp). An audible
and sensible click shows you that the
adjusted value has been reached.
After the first assembly there might be a
warping of the wood. We would therefore
recommend to loosen and tighten the
bedding screws again after some time.
Check the tight fit of the screws before every
shooting.
Cocking, loading and safety
operation
.Degrease the bolt and the interior of the
barrel without leaving lint.
.Then insert the filled magazine into the
magazine well until you hearthat it caught
the magazine holder.
.Now close the bolt and push it forward
to the stop.
.Thus the first cartridge from the magazine
is fed into the barrel and the firing pin is
cocked.
.The rifle is now ready for firing.
.After firing, open the bolt handle and pull
it fully to the rear.
.When the bolt is closed again a new
cartridge will be loaded.
.The rifle is ready for firing again.