Manual

33
Sight Set
Assembly
The rear sight is pushed onto the rail of
11 mm width and fixed with the 2 screws
(tighten manually).
Vertical and horizontal adjustment
The screws for vertical and horizontal
adjustment have clicks. The impact point
changes from click to click.
•Shots are too high:
Turn knob into „H“ direction
•Shots are too low:
Turn knob into „T“ direction
•Shots are too far at the right:
Turn knob into „R“ direction
•Shots are too far at the left:
Turn knob into „L“ direction
Zeroing
After test firing of the rifle both screws
should be brought into the „0“ position.
•Loosen threaded pins in the knob.
•Bring knobs into the „0“ position.
•Tighten threaded pins in the knob
manually.
Cleaning and care
Your ANSCHÜTZ rear sight is a highly
accurate device of utmost quality and
therefore needs special handling. Good
care and maintenance guarantee perfect
functionning. Protect your rear sight from
dust and dirt. Guides and spindles must
not be oiled or greased.
Attention:
Your ANSCHÜTZ rear sight has been
adjusted carefully and without play with the
help of special tools. It has been checked
several times and therefore does not require
any additional adjustments. Therefore only
operate the screws for vertical and horizon-
tal adjustments as described above. Do not
turn the screws beyond their stop as this
would cause a permanent damage to the
screw and thread. In order not to endanger
your right of warranty, please contact your
dealer or our repair service in case any
malfunctions might occur.
Cleaning, Maintenance, Care,
Lubrication
Even after considerable use, your
ANSCHÜTZ small bore match rifle will not
require much attention - a tribute to its solid
design, first class materials, well proven
ANSCHÜTZ workmanship and precision.
If you follow the recommendations below,
you will help maintain the excellent
performance of your rifle for a long time.
If the rifle comes from the cold into warmth
after test firing or after competition,
condensed water is deposited especially on
metal parts and in the interior of the barrel.
If this condensed water is not removed
quickly, rust might occur. Rust makes the
interiour of the barrel rough and the
shooting performance will decrease.
Before initial shooting:
•Carefully deoil the rifle. Deoiling should
be carried out at room temperature as too