Manual
31
there might be a malfunction and an
increased risk (inadvertent shot
release).
8. Change of single stage trigger into
two-stage trigger
•Turn trigger stop set screw No. 8 approx.
2
1
/
2
turns to the left (adjust max. trigger
stop longer).
•Release the safety of the trigger and cock
the rifle.
•Turn set screw No. 5 approx. 2
1
/
2
turns
counter-clockwise.
•You should now feel a second stage
•To adjust the optimum sear engagement
proceed according to paragraph 3.
•Perhaps you have to adjust the first stage
according to paragraph 4, the trigger
stop according to paragraph 5, the
trigger weight according to paragraph 1
and the first stage weight according to
paragraph 2 to the desired values.
9. Malfunctions of the trigger due to
wrong adjustment procedure
If the trigger is not adjusted correctly mal-
functions may occur. Tampering with the
trigger adjustments will not result in any
success. Therefore proceed as follows:
After every change the function of the
trigger must be checked. When the
malfunction is removed check the desired
trigger values and adjust them again if
necessary.
The trigger catches the firing pin, but the
trigger does not release:
•Make sure that the safety of the trigger is
released.
•Check if there is a trigger cam and that it
is attached correctly.
•The trigger stop set screw No. 8 is
screwed in too much. Turn it a few turns
to the left until the cocking piston or firing
pin will release again.
The trigger does not catch the cocking
piston or firing pin:
•Set screw No. 4 (first stage) is screwed
in too much.
•Check to see if the spring is correctly
attached and not defective.
The first stage trigger is adjusted too
tightly:
•Turn set screw No. 5 stepwise
1
/
4
turn to
the right until the firing pin is caught.
Catch rebound spring is too weak or
defective:
•Send your trigger to the factory or your
service center for inspection.
10. Safety
On the left side of the trigger there is a
safety lever. Please see chapter „Cocking,
loading and safety operation“.
11. Maintenance
Please see chapter „Cleaning, mainte-
nance, care, lubrication“.
Important note:
To protect your highly accurate trigger and
to maintain perfect functioning always close
the bolt carefully.