Manual

28
i
r
et
uo
pa sd f
Trigger adjustments
1. Trigger weight
Adjust the trigger weight with set screw
No. 10 (silver screw):
•if you turn it to the right:
trigger weight is increased (+)
•if you turn it to the left:
trigger weight is decreased (-)
Trigger weight and first stage weight
depend on each other with regard to the
mechanic mechanism. If one of them is
changed there will always be a corres-
ponding change of the other as well.
To move trigger cam No. 11:
•lowest position of the trigger cam:
lowest trigger weight
•highest position of the trigger cam:
highest trigger weight
If the trigger weight is to be more than 200 g,
the trigger cam No. 11 must be adjusted to
the highest position (turn it by 180° and fix
it then). To do this you need a 2 mm hex
key and perhaps tweezers.
•if you turn it to the left:
You release the screw
•if you turn it to the right:
You tighten the screw
Attention:
Please ensure the trigger cam is positioned
correctly. Be very careful tightening the
small cam screw as it is easily broken!
Please check the sear engagement accor-
ding to paragraph No. 3 when you have
finished this process. It might have to be
adjusted as well. The precise adjustments
of the trigger weight and first stage weight
are carried out with the set screws No. 10
(trigger weight) and No.9 (first stage weight).
2. First stage weight (only for two-stage
triggers)
Adjust first stage weight with set screw
No. 9 (black screw):
•if you turn it to the right:
first stage weight is increased (+)
Trigger
Warning:
Your ANSCHÜTZ target rifle offers you a
versatility of individual adjusting properties.
Please make sure that your rifle always is
unloaded when carrying out adjustments.
The trigger adjusted by the factory
guarantees utmost safety. Please observe
the general safety use when using your rifle.