Manual

27
considered. (Note: the sequence and
position of the parts can be seen from the
drawing)
•When the thumb spring is screwed in
(approx. 4 turns) make sure that the nut
plate is vertical to the set screw.
•Before assembling the rear bolt part and
the bolt clamping sleeve insert the balls
into the rear bolt part from inside (If you
grease them a little they will not fall out).
•To reassemble the bolt parts attach the
screwed conduit sleeve with its teeth
opposite to the direction of fire to the rear
bolt part thus connecting it to the chamber.
•The screwed conduit sleeve has two
opposing threads each of which is
connected to the referring bolt part.
Tighten screwed conduit sleeve manually
until it is no longer possible to turn the
chamber.
•The tip of the firing pin must protrude over
the action face of the chamber.
To insert the Fortner bolt
The Fortner bolt is inserted into the receiver
in reverse sequence of the removal.