Manual

26
Bolt
To remove the Fortner bolt
•Pull back the bolt (1).
•Pull back the thumb spring (22) a little
and turn it to the right until the groove is
in line with the breech wedge (24).
•Remove the breech wedge by pulling it
backwards.
•Screw off the breech (23).
•Pull back the bolt handle (15) and hold it
under tension. By holding the bolt handle
the locking balls (12) are free of load.
•Remove bolt by pulling it backwards.
To disassemble the Fortner bolt
Attention:
This should only be done by an authorized
expert!
•Screw off screwed conduit sleeve until it
is possible to separate front and rear part.
Do not warp the two bolt parts opposite
to each other.
•Remove spring support and firing pin
spring.
•Remove retaining collar with safety pin
by pulling it upwards.
•Pull bolt handle (15) to the stop.
•Pull bolt clamping sleeve out of the rear
bolt part. To do this you have to overcome
a considerable resistance.
•Press out the locking balls (12) to the
inside.
•Press plunger out of the bolt clamping
sleeve.
•Remove driving pin out of the bolt
clamping sleeve by pulling it upwards.
•Remove firing pin by pulling it back-
wards.
•Screw off thumb spring (22).
•Pull nut plate and spring for thumb spring
out of lateral groove.
To reassemble the Fortner bolt
The bolt is reassembled in reverse
sequence. The following points have to be