User's Manual

19
12.1 Trigger weight setting:
• Turning the setting screw C in a clockwise direction increases
the trigger weight.
• Turning the trigger screw C in a counter-clockwise direction
reduces the trigger weight.
• The factory setting is 1,200 g.
12.2 Setting single stage trigger:
• Cock the rifle.
• Insert a 1.5 mm hexagonal spanner through the rear section of
the trigger and turn the setting screw A in a clockwise direction
until the trigger releases.
• After releasing, turn the setting screw A back by slightly more
than ½ a turn = 35 min. (in a counter-clockwise direction).
• Re-cock the rifle.
• Turn the setting screw B on the trigger sear in a clockwise
direction until the trigger releases.
• After release, the setting screw B must be turned back
(in a counter-clockwise direction) by ¼ turn.
12.3 Setting two stage trigger:
• Please follow the instructions „Single stage trigger setting“
to the end.
• Then turn the setting screw B in a counter-clockwise direction
until you can no longer detect two stage when actuating the
cocked trigger.
• From this point, please turn the setting screw B ¼ turn in a
clockwise direction.
Settings only to be carried out by an
authorised specialist dealer / gunsmith!
NOTE!