Instructions

14
 Pull the bolt [3] out backwards with the releasing lever pushed
down (in the direction of the arrow).
Fig. 2 Bolt open
Fig. 14 Pulling out the bolt
12. Dismantling / assembling the bolt
NOTE!
Dismantling of the bolt should only be carried out
by an authorised specialist.
 Removing the bolt (see Chapter 11).
(See Fig. 15 for the following designations)
 Unscrew the connecting nut (bent) [22] until the front and rear sections
can be separated.
 Remove the spring support [23] and the firing pin spring [24] from the
firing pin [25].
 Press the bolt with its locking pin [27] out downwards.
 Pull the cocking handle [33] back completely.
 Pull the bolt clamping sleeve [30] out from the rear part of the bolt
[26].
 Remove the locking balls [28] by pushing them inwards.
 Push the bolt clamping sleeve [29] out of the bolt clamping sleeve [30].
 Press the driving pin [31] upwards out of the bolt clamping sleeve [30].
 Pull the bolt handle [4] out of the bolt clamping sleeve [30].
 Withdraw the firing pin [25] downwards.
 Release the set screw [35] for the thumb rest [37].
 Pull the thumb rest [37] and breech wedge [36] out backwards.
[3]