User's Manual
The sear engagement on the two-stage trigger is too long:
There is a short travel from the second stage to the release of the trigger
(so-called "pull" or "tug").
X After cocking and releasing the trigger, turn the sear engagement
adjusting screw [1] anti-clockwise in steps (approx.
1
/
8
turn each
time).
X Repeat the procedure until the second stage is no longer percepti-
ble.
X Then turn back
1
/
2
turn clockwise.
9 The optimum sear engagement is now set.
The sear engagement on the two-stage trigger is too short:
There is no longer any second stage. The trigger releases indefinably
without a second stage.
X After cocking, turn the sear engagement adjusting screw [1] at
least
1
/
4
turn clockwise, release the trigger and check whether
there is a second stage.
X If not, repeat the procedure until there is a perceptible second
stage.
X As soon as there is a perceptible second stage, proceed according
to the subsection "If the sear engagement is too long" to achieve
the optimum sear engagement.
Setting the optimum sear engagement with single stage trigger:
X Cock the trigger
X Turn trigger weight adjusting screw [2] (second stage) clockwise
until the trigger releases.
X From this setting, turn trigger weight adjusting screw [2] approx.
1
/
2
turn anti-clockwise.
Danger to life from automatic firing!
Automatically firing shots and malfunctions caused
by minimally set trigger weight and too short a sear
engagement.
h Do not set the trigger weight too low.
h Do not set the sear engagement too short.
Proceed as follows in the event of malfunctions caused by a misadjust-
ed trigger:
X The trigger function must be checked after every change.
X When the malfunction has been rectified, check the desired trigger
characteristic and adjust it again if necessary.
The trigger catches the firing pin but does not fire when pulled:
y Check whether the safety catch is engaged.
The trigger is not catching the firing pin (single stage trigger set too
tight):
y Turn the sear engagement [2] approx. 1 – 2 turns anti-clockwise
and then proceed as per "Sear engagement with two-stage trigger
is too long".