User's Manual

 
X First slide the compression spring for the firing pin [f] over the firing
pin [f], followed by the front spring support [g].
X Slide the front spring support back to the stop and turn slightly to
the right or left (approx.
1
/
4
turn). Then allow to click in place.
X Hold the chamber [h] vertically.
X Place the bolt handle [g] on to the end of the chamber and rotate
with respect to each other (the lowest point of the sloping cocking
cam on the bolt handle [g] and the longitudinal slot of the end of
the chamber must be in line).
X Insert the complete firing pin with compression spring [f] and the
front spring support, point first, into the chamber [h] so that its lug
penetrates into the longitudinal slot.
X Place the cover sleeve [e] and rear spring support [d] (slot open-
ings must face forwards) on to the rear end of the chamber (the
lugs on these parts which face inwards or outwards must engage
with the longitudinal slot on the chamber [h]).
X Insert the indicator pin [c] and compression spring [b].
X Screw cap [a] in position.
Before inserting the assembled action in the receiver,
the action needs to be cocked again by forceful
tilting to the left or the right (by twisting the bolt
handle [h] against the action).


 
[2][1][2][1]
Fig.20 Trigger

1 Adjusting screw for sear engagement (factory setting!)
2 Trigger weight adjusting screw
