Manual

The trigger catches the firing pin, but the
trigger does not release:
-
Make sure that the safety of the trigger is
released.
-
Check if there is a trigger cam and that it
is attached correctly.
-The trigger stop set screw No.8 is
screwed in too much. Turn it a few turns
to the left (counter-clockwise) until the
cocking piston or firing pin will release
again.
The trigger does not catch the cocking
piston or firing pin:
-
Set screw No.4 (first stage) is screwed in
too much.
-
Check to see if the spring is correctly
attached and not defective.
The first stage trigger is adjusted too
tightly:
-Turn setscrew No.5 stepwise 1/4 turn to
the right (clockwise) until the firing pin is
caught.
Catch rebound spring is too weak or
defective:
-
Send your trigger to the factory or your
service center for inspection.
10. Safety
On the left side of the trigger there is a
safety lever. Please see chapter "Cocking,
loading and safety operation".
11. Maintenance
Please see chapter "Cleaning, mainte-
nance, care, lubrication".
45