User's Manual

Always look out for any changes or damage that
may occur to the rifle.
In the event of a change or damage, the rifle must
immediately be taken to an authorised gunsmith or
sent to ANSCHÜTZ for inspection.
CAUTION!
The rifle should be protected from dust, sand, moisture,
heat and damaging influences.
NOTE!
To reduce the risk of breaking the stock during
transport, ANSCHÜTZ recommends separating the
barrelled action from the stock, especially during
air travel.
NOTE!
After each use of the rifle, apply a thin film of oil to
the steel parts and thoroughly clean the barrel.
When the rifle is transported from cold to warm
rooms, condensation can form on the metal parts
and inside the barrel. If this condensation is not
quickly dried off, it can possibly lead to surface rust.
No other aids (felt plugs, non-approved grease, etc.)
should be used for cleaning the barrel.
NOTE!
The rifle case/soft case should be cleaned regularly
and any dust and fluff removed.
Rifle cases and soft cases should have a smooth,
dust-repellent lining.
When not in use, the rifle case/soft case should
always be left open to allow moisture to escape.
Enclosing a desiccant can reduce the moisture
content.
NOTE!
22
Please clean your rifle – particularly the bolt –
after each use, when using a silencer.
Please also observe the cleaning instructions
provided by your silencer manufacturer!
NOTE!