User Manual

ManualsBrandsANS ManualsPaintballGX-3 / GX-4

CONTENTS:

4) GX-4 New Features

• New Front-End Pneumatic Kit

• New Adjustable Drop Forward

Assembly

• New Swing Trigger System

• Packaged Barrel

2) Maintenance

General Notes

3) Installation

X-2 Inline Regulator

4) Adjustments

• X2 Inline Regulator

• Jack Hammer II

Front Pneumatic Regulator

• 3-Way Shaft

• Sear Lug

USER MANUAL

ANS Xtreme Performance

3885 Cochran Unit R

Simi Valley, CA 93063

phone: (805) 527-5661

fax: (805) 527-2490

email: technical@ansxtreme.com

www.ansxtreme.com

www.ansusergroup.com

GX-3 / GX-4

Summary of content (6 pages)

PAGE 1
GX-3 / GX-4 USER MANUAL CONTENTS: 4) GX-4 New Features • New Front-End Pneumatic Kit • New Adjustable Drop Forward Assembly • New Swing Trigger System • Packaged Barrel 2) Maintenance General Notes 3) Installation X-2 Inline Regulator 4) Adjustments • X2 Inline Regulator • Jack Hammer II Front Pneumatic Regulator • 3-Way Shaft • Sear Lug ©2003 ANS Xtreme Performance ANS Xtreme Performance 3885 Cochran Unit R Simi Valley, CA 93063 phone: (805) 527-5661 fax: (805) 527-2490 email: technical@ansxtreme.
PAGE 2
ANS GX-3/GX-4 USER MANUAL GX-4 New Features The GX-4 marker comes with the same quality engineering and style that you’ve come to expect from ANS, plus a load of new features that improve performance, looks, and value. ANS GX-3/GX-4 USER MANUAL Maintenance INSTALLATION STEPS: GX-3 and GX-4 Maintenance Information 1. Identify the four ports on the inline regulator: GENERAL NOTES • IMPORTANT: If CO2 is used, it must be an Anti-siphon tank on both the GX-3 and GX-4 Cocker.
PAGE 3
ANS GX-3/GX-4 USER MANUAL 3. Loosen (counterclockwise) the Quick Twist knob about 2 turns. 4. Open the gas valve to pressure up the marker. Nothing should happen because there is no tension on the Belleview washers inside the regulator. 5. Tighten (clockwise) the Quick Twist knob. This will compress the washers and allow pressure to flow into the marker. The microgauge will begin to register a pressure reading and the regulator will tighten against the body of the marker.
PAGE 4
ANS GX-3/GX-4 USER MANUAL Marker timing is ADVANCED if when the trigger is pulled slowly, the marker fires way before the back block starts to moves back. This indicates that there is too little contact between the lug and the sear creating a large gap in the firing sequence. Marker timing is DELAYED if when the trigger is pulled slowly, the back block moves back before the marker fires. This indicates that there is too much contact between the lug and the sear. Sear Lug timing check is now complete. 6.
PAGE 5
ANS GX-3/GX-4 USER MANUAL ANS GX-3/GX-4 USER MANUAL BLOCK PLUG ON/OFF 8 ANS Xtreme Performance: GX-3/GX-4 User Manual ANS Xtreme Performance: GX-3/GX-4 User Manual 9
PAGE 6
ANS GX-3/GX-4 USER MANUAL 10 ANS Xtreme Performance: GX-3/GX-4 User Manual